Chapter 4
| System Management Commands
Frame Size
– 139 –
Syntax
[no] fan-speed force-full
Default Setting
Normal speed
Command Mode
Global Configuration
Example
Console(config)#fan-speed force-full
Console(config)#
Frame Size
This section describes commands used to configure the Ethernet frame size on the
switch.
jumbo frame This command enables support for layer 2 jumbo frames for Gigabit and 10 Gigabit
Ethernet ports. Use the no form to disable it.
Syntax
[no] jumbo frame
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† This switch provides more efficient throughput for large sequential data
transfers by supporting layer 2 jumbo frames on Gigabit and 10 Gigabit
Ethernet ports or trunks up to 10240 bytes. Compared to standard Ethernet
frames that run only up to 1.5 KB, using jumbo frames significantly reduces the
per-packet overhead required to process protocol encapsulation fields.
â—† To use jumbo frames, both the source and destination end nodes (such as a
computer or server) must support this feature. Also, when the connection is
Table 15: Frame Size Commands
Command Function Mode
jumbo frame Enables support for jumbo frames GC
To Next Page
Loading...
Need help?
General