Chapter 24
| Multicast Filtering Commands
Static Multicast Routing
– 689 –
Static Multicast Routing
This section describes commands used to configure static multicast routing on
the switch.
ip igmp snooping vlan
mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Warn Rate Limit The rate at which received query messages of the wrong version type
cause the Vx warning count to increment. Note that “0 sec” means that
the Vx warning count is incremented for each wrong message version
received.
V1 Warning Count The number of times the query version received (Version 1) does not
match the version configured for this interface.
V2 Warning Count The number of times the query version received (Version 2) does not
match the version configured for this interface.
V3 Warning Count The number of times the query version received (Version 3) does not
match the version configured for this interface.
Table 127: show ip igmp snooping statistics vlan query - display description
Field Description
Table 128: Static Multicast Interface Commands
Command Function Mode
ip igmp snooping vlan
mrouter
Adds a multicast router port GC
show ip igmp snooping
mrouter
Shows multicast router ports PE
To Next Page
Loading...
Need help?
General