Chapter 4
| System Management Commands
Event Logging
– 171 –
The following example displays settings for the trap function.
Console#show logging trap
Status : Disabled
Facility Type : Local use 7 (23)
Level Type : Debugging messages (7)
Remote Host 1 :
Server IP Address : 192.168.2.99
Port : 514
Console#
Related Commands
show logging sendmail (175)
Table 21: show logging flash/ram - display description
Field Description
Syslog Logging Shows if system logging has been enabled via the logging on
command.
History Logging in Flash The message level(s) reported based on the logging history command.
History Logging in RAM The message level(s) reported based on the logging history command.
Table 22: show logging trap - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
Status Shows if remote logging has been enabled via the logging trap
command.
Facility type The facility type for remote logging of syslog messages as specified in
the logging facility command.
Level type The severity threshold for syslog messages sent to a remote server as
specified in the logging trap command.
Server IP address The address of syslog servers as specified in the logging host
command.
Port The UDP port of syslog servers as specified in the logging host
command
To Next Page
Loading...
Need help?
General