Chapter 4
| System Management Commands
File Management
– 148 –
unit - Unit identifier. (Range: 1-8)
boot-rom
- Boot ROM (or diagnostic) image file.
config - Switch configuration file.
opcode - Run-time operation code image file.
filename - Name of configuration file or code image. If this file exists but
contains errors, information on this file cannot be shown.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
â—† If you enter the command dir without any parameters, the system displays all
files.
â—† A colon (:) is required after the specified unit number.
File information is shown below:
Example
The following example shows how to display all file information:
Console#dir
File Name Type Startup Modify Time Size(bytes)
-------------------------- -------------- ------- ------------------- ----------
Unit 1:
ECS4620-28T_V1.2.2.26.bix OpCode Y 2000-12-31 00:19:13 18601012
Factory_Default_Config.cfg Config N 2000-12-31 00:00:32 455
startup1.cfg Config Y 2000-01-01 02:31:23 2924
-----------------------------------------------------------------------------
Free space for compressed user config files: 65220608
Console#
Table 17: File Directory Information
Column Heading Description
File Name The name of the file.
File Type File types: Boot-Rom, Operation Code, and Config file.
Startup Shows if this file is used when the system is started.
Modify Time The date and time the file was last modified.
Size The length of the file in bytes.
To Next Page
Loading...
Need help?
General