Chapter 4
| System Management Commands
Banner Information
– 118 –
hostname This command specifies or modifies the host name for this device. Use the no form
to restore the default host name.
Syntax
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
â—† The host name specified by this command is displayed by the show system
command and on the Show > System web page.
â—† This command and the prompt command can be used to set the command line
prompt as shown in the example below. Using the no form of either command
will restore the default command line prompt.
Example
Console(config)#hostname RD#1
Console(config)#
Banner Information
These commands are used to configure and manage administrative information
about the switch, its exact data center location, details of the electrical and network
circuits that supply the switch, as well as contact information for the network
administrator and system manager. This information is only available via the CLI
and is automatically displayed before login as soon as a console or telnet
connection has been established.
Table 10: Banner Commands
Command Function Mode
banner configure Configures the banner information that is displayed before
login
GC
banner configure company Configures the Company information that is displayed by
banner
GC
banner configure
dc-power-info
Configures the DC Power information that is displayed by
banner
GC
banner configure
department
Configures the Department information that is displayed
by banner
GC
To Next Page
Loading...
Need help?
General