Chapter 4
| System Management Commands
Stacking
– 198 –
Stacking
This section includes commands which configure a unit as the stack master, set the
10G ports to stacking mode, or renumber all units in the stack.
For information on
how to physically connect units into a stack, see the Hardware Installation
Guide. For detailed information on how stacking is implemented for this
type of switch, refer to
“Stack Operations” on page 69.
switch all renumber This command resets the switch unit identification numbers in the stack. All stack
members are numbered sequentially starting from the top unit for a non-loop
stack, or starting from the Master unit for a looped stack.
Syntax
switch all renumber
Default Setting
◆ For non-loop stacking, the top unit is unit 1.
◆ For loop stacking, the master unit is unit 1.
Command Mode
Privileged Exec
Command Usage
The system will restart after renumbering is completed.
Example
This example shows how to renumber all units.
Console#switch all renumber
Console#
Table 28: Stacking Commands
Command Function Mode
switch all renumber Renumbers stack units PE
switch master button Configures a unit as the stack master PE
switch stacking button Sets the front panel 10G ports to stacking mode PE
show switch master button Shows the status of the master button PE
show switch stacking
button
Shows the status of the stacking button PE
show switch stacking
interfaces
Shows if the stacking ports are up or down PE
To Next Page
Loading...
Need help?
General