EasyManua.ls Logo

Edge-Core ECS4620-28T

Edge-Core ECS4620-28T
1260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2
| Using the Command Line Interface
Entering Commands
– 101 –
Exec Commands When you open a new console session on the switch with the user name and
password ā€œguest,ā€ the system enters the Normal Exec command mode (or guest
mode), displaying the ā€œConsole>ā€ command prompt. Only a limited number of the
commands are available in this mode. You can access all commands only from the
Privileged Exec command mode (or administrator mode). To access Privilege Exec
mode, open a new console session with the user name and password ā€œadmin.ā€ The
system will now display the ā€œConsole#ā€ command prompt. You can also enter
Privileged Exec mode from within Normal Exec mode, by entering the enable
command, followed by the privileged level password ā€œsuper.ā€
To enter Privileged Exec mode, enter the following user names and passwords:
Username: admin
Password: [admin login password]
CLI session with the ECS4620-28T is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the ECS4620-28T is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#
Table 3: General Command Modes
Class Mode
Exec Normal
Privileged
Configuration
Global
*
Access Control List
CFM
Class Map
DHCP
ERPS
IGMP Profile
Interface
Line
Multiple Spanning Tree
Policy Map
Route Map
Router
Time Range
VLAN Database
* You must be in Privileged Exec mode to access the Global configuration mode.
You must be in Global Configuration mode to access any of the other configuration modes.

Table of Contents

Other manuals for Edge-Core ECS4620-28T

Related product manuals