Chapter 24
| Multicast Filtering Commands
MLD Proxy Routing
– 789 –
Querier : FE80::200:E8FF:FE93:82A0
Joined Groups :
Static Groups :
FFEE::101
Console#
MLD Proxy Routing
This section describes commands used to configure MLD Proxy Routing on the
switch.
To enable MLD proxy service, follow these steps:
1. Use the ipv6 multicast-routing command to enable IP multicasting globally on
the router.
2. Use the ipv6 mld proxy command to enable MLD proxy on the upstream
interface that is attached to an upstream multicast router.
3. Use the ipv6 mld command to enable MLD on the downstream interfaces from
which to forward MLD membership reports.
4. Optional – Use the ipv6 mld proxy unsolicited-report-interval command to
indicate how often the system will send unsolicited reports to the upstream
router.
ipv6 mld proxy This command enables MLD proxy service for multicast routing, forwarding MLD
membership information monitored on downstream interfaces onto the upstream
interface in a summarized report. Use the no form to disable proxy service.
Syntax
[no] ipv6 mld proxy
Default Setting
Disabled
Table 158: IGMP Proxy Commands
Command Function Mode
ipv6 mld proxy Enables MLD proxy service for multicast routing IC
ipv6 mld proxy unsolicited-
report-interval
Specifies how often the upstream interface should
transmit unsolicited IGMP reports
IC
show ipv6 mld interface Displays multicast information for the specified interface PE
To Next Page
Loading...
Need help?
General