EasyManua.ls Logo

Edge-Core ECS4620-28T

Edge-Core ECS4620-28T
1260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3
| General Commands
– 111 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
ā—† This command resets the entire system.
ā—† Any combination of reload options may be specified. If the same option is re-
specified, the previous setting will be overwritten.
ā—† When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the
copy running-config startup-config command (See ā€œcopyā€ on page 142).
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2016 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable This command activates Privileged Exec mode. In privileged mode, additional
commands are available, and certain commands display additional information.
See ā€œUnderstanding Command Modesā€ on page 100.
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
ā—† ā€œsuperā€ is the default password required to change the command mode from
Normal Exec to Privileged Exec. (To set this password, see the enable password
command.)

Table of Contents

Other manuals for Edge-Core ECS4620-28T

Related product manuals