Chapter 29
| DHCP Commands
DHCP Server
– 892 –
DHCP Server
This section describes commands used to configure client address pools for the
DHCP service.
Table 179: DHCP Server Commands
Command Function Mode
ip dhcp excluded-address Specifies IP addresses that a DHCP server should not assign
to DHCP clients
GC
ip dhcp pool Configures a DHCP address pool on a DHCP Server GC
service dhcp Enables the DHCP server feature on this switch GC
bootfile Specifies a default boot image for a DHCP client DC
client-identifier
*
Specifies a client identifier for a DHCP client DC
default-router Specifies the default router list for a DHCP client DC
dns-server Specifies the Domain Name Server (DNS) servers available
to a DHCP client
DC
domain-name Specifies the domain name for a DHCP client DC
hardware-address
*
Specifies the hardware address of a DHCP client DC
host
*
* These commands are used for manually binding an address to a client.
Specifies the IP address and network mask to manually
bind to a DHCP client
DC
lease Sets the duration an IP address is assigned to a DHCP client DC
netbios-name-server Configures NetBIOS Windows Internet Naming Service
(WINS) name servers available to Microsoft DHCP clients
DC
netbios-node-type Configures NetBIOS node type for Microsoft DHCP clients DC
network Configures the subnet number and mask for a DHCP
address pool
DC
next-server Configures the next server in the boot process of a DHCP
client
DC
clear ip dhcp binding Deletes an automatic address binding from the DHCP
server database
PE
show ip dhcp Displays brief list of DHCP address pools PE
show ip dhcp binding Displays address bindings on the DHCP server PE
show ip dhcp pool Displays configuration settings for DHCP address pools PE
To Next Page
Loading...
Need help?
General