EasyManua.ls Logo

Edge-Core ECS4620-28T

Edge-Core ECS4620-28T
1260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 95 –
2 Using the Command Line
Interface
This chapter describes how to use the Command Line Interface (CLI).
Note
:
You can only access the console interface through the Master unit in the
stack.
Accessing the CLI
When accessing the management interface for the switch over a direct connection
to the server’s console port, or via a Telnet or Secure Shell connection (SSH), the
switch can be managed by entering command keywords and parameters at the
prompt. Using the switch's command-line interface (CLI) is very similar to entering
commands on a UNIX system.
Console Connection To access the switch through the console port, perform these steps:
1. At the console prompt, enter the user name and password. (The default user
names are ā€œadminā€ and ā€œguestā€ with corresponding passwords of ā€œadminā€ and
ā€œguest.ā€) When the administrator user name and password is entered, the CLI
displays the ā€œConsole#ā€ prompt and enters privileged access mode
(i.e., Privileged Exec). But when the guest user name and password is entered,
the CLI displays the ā€œConsole>ā€ prompt and enters normal access mode
(i.e., Normal Exec).
2. Enter the necessary commands to complete your desired tasks.
3. When finished, exit the session with the ā€œquitā€ or ā€œexitā€ command.
After connecting to the system through the console port, the login screen displays:
User Access Verification
Username: admin
Password:
CLI session with the ECS4620-28T is opened.
To end the CLI session, enter [Exit].
Console#

Table of Contents

Other manuals for Edge-Core ECS4620-28T

Related product manuals