Chapter 29
| DHCP Commands
DHCP Server
– 894 –
Example
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#
Related Commands
network (901)
host (898)
service dhcp This command enables the DHCP server on this switch. Use the no form to disable
the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
If the DHCP server is running, you must restart it to implement any configuration
changes.
Example
Console(config)#service dhcp
Console(config)#
bootfile This command specifies the name of the default boot image for a DHCP client. This
file should placed on the Trivial File Transfer Protocol (TFTP) server specified with
the next-server command. Use the no form to delete the boot image name.
Syntax
bootfile filename
no bootfile
filename - Name of the file that is used as a default boot image.
Default Setting
None
Command Mode
DHCP Pool Configuration
To Next Page
Loading...
Need help?
General