Edge-Core ECS4620-28T

Chapter 8 | Authentication Commands
802.1X Port Authentication
– 298 –
◆ Authenticator Parameters – Shows whether or not EAPOL pass-through is
enabled (page 286).
◆ Supplicant Parameters – Shows the supplicant user name used when the switch
responds to an MD5 challenge from an authenticator (page 294).
◆ 802.1X Port Summary – Displays the port access control parameters for each
interface that has enabled 802.1X, including the following items:
■
Type – Administrative state for port access control (Enabled, Authenticator,
or Supplicant).
■
Operation Mode – Allows single or multiple hosts (page 289).
■
Control Mode – Dot1x port control mode (page 290).
■
Authorized – Authorization status (yes or n/a - not authorized).
◆ 802.1X Port Details – Displays the port access control parameters for each
interface, including the following items:
■
Reauthentication – Periodic re-authentication (page 290).
■
Reauth Period – Time after which a connected client must be re-
authenticated (page 291).
■
Quiet Period – Time a port waits after Max Request Count is exceeded
before attempting to acquire a new client (page 291).
■
TX Period – Time a port waits during authentication session before re-
transmitting EAP packet (page 293).
■
Supplicant Timeout – Supplicant timeout.
■
Server Timeout – Server timeout. A RADIUS server must be set before the
correct operational value of 10 seconds will be displayed in this field.
■
Reauth Max Retries – Maximum number of reauthentication attempts.
■
Max Request – Maximum number of times a port will retransmit an EAP
request/identity packet to the client before it times out the authentication
session (page 288).
■
Operation Mode– Shows if single or multiple hosts (clients) can connect to
an 802.1X-authorized port.
■
Port Control–Shows the dot1x mode on a port as auto, force-authorized, or
force-unauthorized (page 290).
■
Intrusion Action– Shows the port response to intrusion when
authentication fails (page 287).
■
Supplicant– MAC address of authorized client.
◆ Authenticator PAE State Machine
■
State – Current state (including initialize, disconnected, connecting,
authenticating, authenticated, aborting,
held, force_authorized,
force_unauthorized).
■
Reauth Count– Number of times connecting state is re-entered.
■
Current Identifier– The integer (0-255) used by the Authenticator to identify
the current authentication session.