Edge-Core ECS4620-28T

Chapter 9 | General Security Measures
Network Access (MAC Address Authentication)
– 323 –
◆ When used with 802.1X authentication, the intrusion-action must be set for
“guest-vlan” to be effective (see the dot1x intrusion-action command).
◆ A port can only be assigned to the guest VLAN in case of failed authentication,
if switchport mode is set to Hybrid.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access
link-detection
Use this command to enable link detection for the selected port. Use the no form of
this command to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#