Chapter 24
| Multicast Filtering Commands
MVR for IPv6
ā 755 ā
mvr6
robustness-value
This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr6 robustness-value value
no mvr6 robustness-value
value - The robustness used for all interfaces. (Range: 1-10)
Default Setting
2
Command Mode
Global Configuration
Command Usage
ā This command sets the number of times report messages are sent upstream
when changes are learned about downstream groups, and the number of times
group-specific queries are sent to downstream receiver ports.
ā This command only takes effect when MVR6 proxy switching is enabled.
Example
Console(config)#mvr6 robustness-value 5
Console(config)#
Related Commands
mvr6 proxy-switching (753)
mvr6
source-port-mode
dynamic
This command configures the switch to only forward multicast streams which the
source port has dynamically joined. Use the no form to restore the default setting.
Syntax
[no] mvr6 source-port-mode dynamic
Default Setting
Forwards all multicast streams which have been specified in a profile and bound to
a domain.
Command Mode
Global Configuration
Command Usage
ā By default, the switch forwards any multicast streams within the address range
set by a profile, and bound to a domain. The multicast streams are sent to all
To Next Page
Loading...
