Chapter 25
| LLDP Commands
– 796 –
lldp
med-fast-start-count
This command specifies the amount of MED Fast Start LLDPDUs to transmit during
the activation process of the LLDP-MED Fast Start mechanism. Use the no form to
restore the default setting.
Syntax
lldp med-fast-start-count packets
no lldp med-fast-start-count
seconds - Amount of packets. (Range: 1-10 packets; Default: 4 packets)
Default Setting
4 packets
Command Mode
Global Configuration
Command Usage
This parameter is part of the timer which ensures that the LLDP-MED Fast Start
mechanism is active for the port. LLDP-MED Fast Start is critical to the timely
startup of LLDP, and therefore integral to the rapid availability of Emergency Call
Service.
Example
Console(config)#lldp med-fast-start-count 6
Console(config)#
lldp
notification-interval
This command configures the allowed interval for sending SNMP notifications
about LLDP MIB changes. Use the no form to restore the default setting.
Syntax
lldp notification-interval seconds
no lldp notification-interval
seconds - Specifies the periodic interval at which SNMP notifications are
sent. (Range: 5 - 3600 seconds)
Default Setting
5 seconds
Command Mode
Global Configuration
Command Usage
â—† This parameter only applies to SNMP applications which use data stored in the
LLDP MIB for network monitoring or management.
To Next Page
Loading...
Need help?
General