EDWARDS SYSTEMS TECHNOLOGY EST3 - Guard Patrol

Introduction
1.12 EST3 System Operation Manual
Optional features
The EST3 system can be configured with many optional features
that provide additional capabilities. Your system may include
some or all of these options, depending on the needs of your
facility. See the site-specific information provided by your
system installer to determine which options are installed.
Guard patrol
The guard patrol feature is used to monitor the activities of
security guards. Guards are required to walk any one of a
number of predetermined routes called tours. During each tour,
the guard must activate guard patrol stations that are
strategically located along the route. Should a guard activate a
station too early, too late, or out of sequence, an active guard
patrol message will be displayed on the 3-LCD display module.
[PATROL2.CDR]
1
3
5
2
4
10 to 15 minutes
8
to
10
m
in
u
te
s
7 to 10 minutes
1
2
t
o 18 min
u
te
s
Tour #1
1
3
5
2
4
Tour #3
8
t
o
1
0
m
i
n
u
t
e
s
3
5
t
o
4
0
m
i
n
u
t
e
s
3 to 5 minutes
25 to 30 minutes
Tour #
5
1
3
5
2
4
14 to 18 minutes
1
1
t
o
1
4
m
i
n
u
t
e
s
12 to 18
m
inutes
7 to 10 minutes
Tour #2
1
3
5
2
4
14 to 18 minutes
1
2
t
o 18 min
u
te
s
7 to 10 minutes
3 to 5 minutes
Tour #4
1
3
5
2
4
10 to 15 minutes
7 to 10 minutes
7
t
o
1
0
m
i
n
u
t
e
s
3 to 5 minutes
Patrol Group Notes
1 Any station activated early, late, or out
of sequence will generate a guard
patrol alarm.
2 If a guard patrol alarm is generated,
the guard patrol must be restored to
clear the alarm.
Figure 1-3: Sample guard patrol route assignments
firealarmresources.com