3-LCD operating instructions
2.8 EST3 System Operation Manual
Creating a status report
Use the Status command to create reports of off-normal points,
or to determine the status of points in a security partition. The
Status command generates a list that you can view on the 3-LCD
display module or print on a local printer.
The Status Menu lets you choose the following reports:
• All active points
• Alarm points
• Supervisory points
• Trouble points
• Monitor points
• Test points
• Disabled points
• Output points
• Security points
On the Security Status Menu, you can choose between Partition
and Holdup status reports.
To create a status report:
1. Press the Command Menus button, then choose Status.
2. Choose the type of list you want to generate.
3. Enter the target panel’s 2-digit address (PP).
—or—
Choose a partition from the Partition List.
4. Do one of the following:
Choose Display if you want to view the list on the 3-LCD
module.
Choose Print Locally, then select a printer, if you want to
send the list to a printer connected to the local panel.
To Next Page
Loading...
