3-LCD operating instructions
2.18 EST3 System Operation Manual
Removing bypasses from security devices
When you remove a bypass from a security device, the system
resumes processing the device’s alarm events. The panel will go
into alarm if you remove a bypass from a device while it is in an
active state (i.e., in its otherwise alarm position).
To unbypass a device, you need the device’s logical address.
You can get the logical address from the Disabled Points list.
To remove a bypass from a security device:
1. Press the Command Menus button , then choose Security.
2. Choose Device.
3. Choose Remove Bypass.
4. Enter the logical address of the device.
5. If prompted, enter a valid user access level password.
To Next Page
Loading...
