3-LCD operating instructions
2.26 EST3 System Operation Manual
To create a History report:
1. Press the Command Menus button , then choose Report.
2. Choose History.
3. Choose History With Text or History Without Text.
4. Enter the target panel’s 2-digit address (PP).
5. Send the list to the display or to the printer. If you choose to
send the list to the printer, choose Printer 1 if the printer is
connected to port 1 or Printer 2 if connected to port 2.
To create a Revisions report:
1. Press the Command Menus button , then choose Report.
2. Choose Revision Levels.
3. Enter the target panel’s 2-digit address (PP).
4. Send the list to the display or to the printer. If you choose to
send the list to the printer, choose Printer 1 if the printer is
connected to port 1 or Printer 2 if connected to port 2.
To create a Modcom Compliance report:
1. Press the Command Menus button , then choose Report.
2. Choose Modcom Compliance.
3. Enter the target panel’s 2-digit address (PP).
4. Send the list to the display or to the printer. If you choose to
send the list to the printer, choose Printer 1 if the printer is
connected to port 1 or Printer 2 if connected to port 2.
To Next Page
Loading...
