Edwards EDS 300

Covers
The pump is equipped with covers. These must always be mounted during operaon of the
pump, because they protect the operators from touching hot surfaces and they are required
for the cooling air ow.
4.2 Supplied equipment
1. Pump as described in Design and Pumps
2.
The pumps are lled with lubricant: Ultragrade® Endurance Extend 110
3.
The pump anges have been blanked o with a sealing cap
4.
4x crane eyes M16
5.
Inlet diuser
6.
NW 40 clamping ring & O-ring for exhaust, O-ring for inlet
7.
Pump body thermal snap switch
4.3 Ordering informaon
4.3.1 Pumps
Table 2 Pumps ordering informaon
EDS ATEX Electrical Supply Part No.
EDS 200 water cooled
II 3/-G Ex h IIC T3 Gc
5 °C < Ta < 40 °C
(internal atmospheres only)
200/400 V 50 Hz A41820945
230/460 V 60 Hz A41820946
200 V 50 Hz A41820934
200/380 V 60 Hz A41820936
575 V 60 Hz A41820957
EDS 200 air cooled
200/400 V 50 Hz A41821945
230/460 V 60 Hz A41821946
200 V 50 Hz A41821934
200/380 V 60 Hz A41821936
575 V 60 Hz A41821957
EDS 300 water cooled
200/400 V 50 Hz A41830945
230/460 V 60 Hz A41830946
200/380 V 50 Hz A41830934
200/380 V 60 Hz A41830936
575 V 60 Hz A41830957
EDS 300 air cooled
200/400 V 50 Hz A41831945
230/460 V 60 Hz A41831946
200/380 V 50 Hz A41831934
200/380 V 60 Hz A41831936
575 V 60 Hz A41831957
Page 15