Edwards EDS 300

6. Transport and storage
CAUTION: LOSS OF STABILITY DURING TRANSPORT
Uncontrolled movement due to faulty aaching/liing/carrying/rolling or moving the
vacuum pump. For vercal and horizontal transport, use only the aachment points and
transport means described in this manual.
NOTICE:
The pumps are supplied lled with synthec oil. For this reason they should, while being
transported or shipped, not be subjected to much lng (10° max.). Store the pumps only
horizontally standing on their feet.
Use a suitable fork-li truck or pallet truck to move the pump on its pallet, close to where
you will install it.
Remove all packing materials.
Li the pump at the crane eyes. Use all crane eyes. Ensure that it cannot p over.
Figure 3 Liing the EDS pump
A - max. 45
0
6.1 Storage
Store the pumps only horizontally standing on their feet.
Open the pumps only immediately before installing them.
NOTICE:
If there is the danger of frost, the cooling-water must be drained.
You may use a water glycol mixture of up to 50 %
Page 20
A41802880_C - Transport and storage