SpeedStream Router User Guide
Step On this window: Do this:
session, steps 7-11 will repeat.
10
User Information Enter user name and password (both are optional).
11
PPP Options Select PPP options for this connection: dial-up mode, auto-connect on
disconnect, idle timeout.
12
PPP Static IP Enter static IP address (optional).
13
Interface Options Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
14
Connection Name Enter name to use for this connection. If multiple sessions were selected,
repeat steps 7-11 until last session is configured; then go to step 6.
15
VC Wizard Finish.
5e. If you selected the PPPoA protocol:
Step On this window: Do this:
5e
User Information Enter user name and password (both are optional).
6
PPP Options Select PPP options for this connection: dial-up mode, auto-connect on
disconnect, idle timeout.
7
PPP Static IP Enter static IP address (optional).
8
Interface Options Select interface options: firewall, attack detection system, universal plug
and play; RIP; NAT/NAPT.
9
Connection Name Enter name to use for this connection.
10
VC Wizard Finish.
113
To Next Page
Loading...