SpeedStream Router User Guide
2: Installing the Router
Minimum System Requirements
At a minimum, your computer must be equipped with the following.
For Ethernet port connectivity (5100, 5200, 5400, 5500 series): •
•
- A network interface card (NIC) that supports Ethernet 10/100Base-T full-/half-duplex
- Operating system that supports TCP/IP
- Microsoft Internet Explorer or Netscape Navigator versions 5.0 or later
- USB Port Connectivity (5200, 5500 series)
For USB port connectivity (5200, 5500 series):
- 32 MB RAM.
- Pentium-compatible 166 MHz processor (or faster).
- 12 MB available hard disk space.
- Windows 98 or later operating system.
- Must meet manufacturer’s minimum requirements for USB.
Important! Your specific configuration may vary slightly from the instructions and illustrations in this
chapter. Refer to your service provider’s documentation, or contact them with questions regarding your
specific configuration.
Hardware Installation
You may position the SpeedStream router at any convenient location in your office or home. No special
wiring or cooling requirements are needed; however, you should comply with the safety guidelines
specified in the General Safety Guidelines on page 3.
Basic Installation Procedure
Install line filters if necessary. 1.
2.
3.
4.
5.
6.
7.
Connect the cables.
Plug the router into the electrical outlet; then verify port status.
Install USB drivers if necessary (5200, 5500 series).
Configure network settings on your computer.
Configure the router via the Web-based management interface.
Reboot the computer if prompted.
4
To Next Page
Loading...
Need help?
General