To Next Page

To Previous Page

SETTING UP THE COPIER TOUCH PANEL 30

Network Security

On, Off

Select Off if you inadvertently closed a port and need to access the EX700i. If you set this

option to Off, the following features are disabled:

• IP Filtering

•Port Filtering

•IPSec

• Mac Address Filtering

5 minutes, 10 minutes, 15 minutes, 30 minutes, 45 seconds, never

Specify the amount of time the EX700i times out after you log on.

When you are done making changes, press Save Changes. The EX700i requires a reboot in

order for any Setup changes to take effect.

802.1x Setup

The EX700i can seek authentication from an 802.1x authentication server (such as a

RADIUS server), often through an intermediate access point (an authenticator). The EX700i

seeks this authentication at startup, or when the Ethernet cable is disconnected and

reconnected. If the EX700i is successfully authenticated, it is allowed access to the network.

Press 802.1x Setup to access 802.1x Setup options.

Enable 802.1x Authentication

Off, On

Select this option to allow the EX700i to seek authentication from an 802.1x authentication

server.

Select EAP Type

PEAP-MSCHAPv2, MD5-Challenge

Choose the type of EAP (Extensible Authentication Protocol).

User name, password

This information is what the EX700i uses to request authentication from an 802.1x

authentication server.

Questions and Answers:

Need help?

Do you have a question about the EFI Fiery EX700i and is the answer not in the manual?

EFI Fiery EX700i Specifications

General