EFI Fiery EX700i - Setting Up the EX700 i from a Network Computer; Accessing Configure from a network computer

SETTING UP THE EX700I FROM A NETWORK COMPUTER 32
SETTING UP THE EX700I FROM A NETWORK COMPUTER
After you perform initial Setup from the digital press touch panel, you can change Setup
options from a network computer using Configure. To use Configure from a network
computer, you must know the EX700i Administrator password.
Accessing Configure from a network computer
To set up the EX700i from a network computer, use Configure. Access Configure as follows:
• WebTools from a supported Internet browser
• Command WorkStation
TO ENABLE ACCESS TO WEBTOOLS, ENSURE THAT THE FOLLOWING ITEMS ARE ENABLED
• A valid, unique IP address, subnet mask, and gateway address for the EX700i.
Print a Configuration page to acquire the EX700i IP address (see page 55).
• Web Services is enabled.
Web Services is enabled by default. To re-enable Web Services if it is disabled, see “Enable
Web Services” on page 29.
TO ACCESS CONFIGURE FROM AN INTERNET BROWSER
1 Start your Internet browser and type the IP address of the EX700i.
2 Click the Configure tab on the EX700i home page.
3 Click Launch Configure.
4 Log on with Administrator privileges.