To Next Page

To Previous Page

ADMINISTERING THE FIERY CONTROLLER 50

Mobile device printing

Direct Mobile Printing enables direct wireless printing to the EX700i from supported mobile

devices. Supported mobile devices must be connected to the same wireless network subnet as

the EX700i to print using Direct Mobile Printing.

EX700i Setup for Direct Mobile Printing

Before using Direct Mobile Printing, configure the following settings in Configure:

• Network > Protocol > TCP/IP > Security:

Specify ports to enable or Enable Port Filtering: Checked

Available Ports > 5353 (Multicast DNS): Checked

Available Ports > 80 (HTTP): Checked

Available Ports > 631 (IPP): Checked

• Network > Services > Web:

Enable Web Services: Checked

Enable IPP: Checked

• Network > Services > Bonjour:

Enable Bonjour: Checked

Enable Direct Mobile Printing: Checked

• Printer > General:

Publish Print Queue: Checked

Make sure that the EX700i settings are configured as specified. Direct Mobile Printing will

not work if these settings are changed.

For more information about these settings, see Command WorkStation Help.

Questions and Answers:

Need help?

Do you have a question about the EFI Fiery EX700i and is the answer not in the manual?

EFI Fiery EX700i Specifications

General