14
Alignthesaddleandxtheseatpost
Attention! The Postpin axis must be tightened to 8Nm after assembly.
Install the outer sleeve screw
Rotate the outer sleeve so that the mounting hole of the
outer sleeve coincides with the mounting hole on the fra-
me. Screw the M5 mounting screw of the outer sleeve into
the outer sleeve using a 3mm Allen key.
Attention! The screw must be able to be screwed into the outer sleeve easily and without resistance. If this is not the
case, the hole in the frame may not coincide with the mounting hole in the outer sleeve. The frame can be squashed
or damaged
After mounting the saddle, the saddle must be rotated in the direction of riding. It is
best to orient it with the saddle tip on the top tube. Then tighten the Postpin axis with a
torque wrench with 8Nm.
To Next Page
Loading...