21
Operation
Adjusting the saddle height
The Eightpins H01 seat post has a height adjustment operating lever in the seat post head. This unlocks and locks the internal height adjustment of
the seat post.
Before the correct height of the saddle can be set, the internal hydraulic gas spring of
the seat post must be fully extended. Simply operate the control lever on the handlebar
and let the seat post extend completely.
Push the lever for the height adjustment from the back to the front to open the height
adjustment. Now pull the saddle up or push it down to the desired height.
As soon as the correct height is found, push the height adjustment control lever from
front to back. If the lever jams, pull the saddle up 1-2mm or push it down. In this way,
the teeth of the height adjustment can interlock again.
ATTENTION! The height adjustment control lever must always be
locked while driving. The lever is in the rear position as far as it
can go.
To Next Page
Loading...