24
Reinstall the seatpost
Hook the cable head into the actuation lever of the
hydraulic gas spring. Push the special bowden end cap
for the outer casing into the cable housing holder of the
postpins mounting interface
Carefully insert the seat post into the frame. Be careful not to damage the wiper and the
sliding surfaces in the bushing tube. During insertion, keep the cable under tension and
pull the entire cable housing carefully out of the frame so that the seat post can slide
down freely.
Push the seat post down until the Postpin mounting interface of the seat post rea-
ches the Pospin interface of the frame. You can see this from the outside when you
look into the hole in the postpin interface of the frame. If necessary, turn the seat post
a little and slide it so that the postpin axle can be inserted.
To Next Page
Loading...