38
Drip blue medium-strength screw locking on the upper brass guide.
Note! Loctite 243 is recommended to use as a screw lock.
Die obe Carefullyscrewthebrassguideintothetubeofthecartridge.Ifitisdi-
cult to move, use the 23mm open-ended wrench for support.
The two lugs of the upper brass guide must be aligned with the longitudi-
nal guide grooves on the tube of the cartridge. To do this, the upper brass
guide does not have to be screwed in as far as it will go, but only so far
that the gap between the tube and the brass guide is minimal and the lugs
onthebrassguidecloseothelongitudinalguidegrooves.
Attention! It is imperative that the brass guide is
installed and the lugs are correctly aligned. Otherwise
the bike can fall down while hanging on the saddle.
There is a high risk of injury!
To Next Page
Loading...