E
43
4 GETTING THE MOST FROM YOUR MONITOR
4-1 Adjustment Lock
The ScreenManager operation can
be disabled by holding down the
AUTO-SIZING button while
switching on the monitor’s power.
This will disable (“lock”) the
ScreenManager and AUTO-SIZING
button, protecting from accidental
changes.
To unlock the buttons: switch the power off, then hold down AUTO-
SIZING button once again and turn the power back on.
Note that brightness and contrast can be adjusted using the short cut keys
(see page 17) even while the Control pad is locked. After making such an
adjustment, push the ENTER key to clear the brightness/contrast adjust-
ment menu from the screen. Also, the BNC/D-Sub Selection button can still
be used.
4-2 Connecting two PCs to the Monitor
(Example)
Connect one PC to the monitor’s D-Sub connector and another to the BNC
connector. The BNC connection should be made with an EIZO BNC cable,
available as an option.
• Be sure that the monitor and the PC are both switched off before
connecting them.
• Be sure to connect the cable securely.
Selecting the active input
• The BNC/D-Sub selection button
on the front panel can be used to
select either BNC or D-Sub
connection as the active input.
• The ScreenManager’s “Input
Priority” setting (in the “Others”
menu) can be used to set up the
automatic selection of the input.
See page 33 for details.
4 GETTING THE MOST FROM
YOUR MONITOR
MD-C53A (optional)
To Next Page
Loading...
Need help?
General