27
Chapter 3 Setting Monitor
Chapter 3 Setting Monitor
3-1. Switching sound source for HDMI signal input
This function allows you to switch sound source for HDMI signal input. You can select the HDMI or stereo
mini jack.
Procedure
1. Choose “Sound” in the Setting menu, and press
.
2. Choose “Source” in the “Sound” menu, and press
.
The “Source” menu appears.
3. Select “HDMI” or “Stereo Mini Jack” with or .
4. Press
to exit the adjustment.
Note
• This function is available with HDMI signal input. However, if a DVI-HDMI adapter cable is used, the sound
source is automatically “Stereo Mini Jack” and cannot be changed.
3-2. Adjusting Volume
●
To turn the volume up/down
This function allows you to adjust the volume.
Adjustable range
0 to 30
Procedure
1. Press
or on the remote control.
Note
• Alternatively, you can use or on the monitor for adjustment (see “1-2. Controls and Functions”
(page 8)).
• The volume setting is common for the HDMI input and stereo mini jack.
Attention
• If a speaker with built-in amplier is attached to the line output connector, adjust the volume on the external
speaker. You cannot adjust the volume using the remote control or control buttons on the monitor.
• When you try to adjust the volume with all the conditions below, “This operation is not available on current
status.” is displayed.
- The headphones are not connected.
- A speaker with built-in amplier is attached to the line output connector.
To Next Page
Loading...
