7
3: Installing the MVB into a
rack
This chapter includes instructions on how to install the EKE-Trainnet
®
MVB
Multifunction Vehicle Bus module into a rack.
The following topics are covered in this chapter:
Before you begin
Installation procedure
Potential problems
3.1 Before you begin
Read the following sections carefully before you start installing the MVB module.
3.1.1 Warnings
This section contains warnings you need to consider before and during the MVB
installation.
Do not turn on the rack power before you have finished the
installation.
Never connect the MVB to, or disconnect it from, a rack with active
power, as this can damage the MVB module or other modules in the
system. Always turn off the rack power first.
Electrostatic discharge can damage electronic circuits. When not handling
the module at a static free workstation, ground yourself using a wrist strap
and a resistive connection cord.
To Next Page
Loading...