Installing the MVB into a rack
10
3.3 Problems in installation
The following table lists some potential problems that can occur during the MVB
installation, as well as their causes, and actions you can take to solve the problem.
Table 3.1: Potential problems in the installation procedure
Problem Potential cause Action
The module does not fit into
the rack.
The connector pins of the
module are be damaged.
Replace the module with a
spare one.
Connector pins are OK, but
the module does not fit into
the rack.
The back plane of the rack is
damaged.
Refer to the documentation
provided by the rack
manufacturer.
You have installed the
module into the rack, but it is
not working: the red SE LED
and yellow UE LED are on.
The module is damaged. Replace the module with a
spare one.
To Next Page
Loading...