Elcometer 345 - Statistical Summary and Data; Statistics Overview; Displaying Statistical Values

R
21
6 STATISTICAL SUMMARY
6.1 STATISTICS
The statistics display on the Elcometer 345 shows a preset combination of the five statistical functions which
may be shown on the display in any user defined order by pressing one key. The feature is switched on by
selecting at least one statistical value to be displayed - see “Setting The User List For Statistical Values” on
page 23. The feature is switched off by selecting OFF. The menu from which the list is created is as follows:
• Number of Readings taken
• Mean value of these Readings
• Standard deviation of these Readings
• Highest Reading taken
• Lowest Reading
• OFF (Switches the statistics off.)
6.2 DISPLAYING STATISTICAL VALUES
• To display a statistical value from the normal measurement mode, press and release or .
This will display for 3 seconds either (+) the first statistical value in the user list or (-) the last statistical
value in the user list.
• If or is released within 4 seconds the gauge will display the value for a further 3 seconds
during which time or can be pressed again. If the key is held for more than 5 seconds the
calibration routine is activated.