5
Thank you for your purchase of this Elcometer 345 Coating Thickness Gauge. Welcome to Elcometer.
Elcometer are world leaders in the design, manufacture and supply of inspection equipment for coatings
and concrete. Our products cover all aspects of coating inspection, from development through application
to post application inspection.
The Elcometer 345 Coating Thickness Gauge is a world beating product. With the purchase of this gauge
you now have access to the worldwide service and support network of Elcometer. For more information visit
our website: www.elcometer.com
1 ABOUT YOUR GAUGE
The Elcometer 345 Coating Thickness Gauge is a hand-held
coating thickness gauge for fast and accurate measurement of the
thickness of coatings on metal substrates.
The gauge is available either with a built-in integral probe or with a
separate probe.
The gauge can be switched to display metric (µm/mm) or imperial
(mils) units of measurement.
Your gauge was calibrated at the factory, however you can adjust
the calibration using the set of calibration foils supplied with the
gauge.
The Elcometer 345 Coating Thickness Gauge is powered by
internal dry cell batteries.
Elcometer
345 with
Integral
Probe
Elcometer 345 with
Separate Probe
To Next Page
Loading...
Need help?
General
