Ÿ Select the appropriate calibration method - Batch/New Batch/
Batch Calibration (see Multiple calibration methods on page 18)
Ÿ Choose the type of batch (normal, counted average or IMO PSPC)
before opening it via Batch/New Batch/Batch Type (see Batch
Types on page 32)
Ÿ Set up specific batch limits via Batch/New Batch/Batch Limits
(see Limits on page 23)
Ÿ Set up a fixed batch size via Batch/New Batch/Fixed Batch Size
(see Fixed Batch Size on page 33)
Once all the batch settings have been created, press Batch/New
Batch/Open Batch 1 - where ‘Batch 1' may now be a re-named as
required.
Alpha numeric naming batches & cal memories (T)
When in batching - or setting up a calibration memory (see Calibration
Memories on page 21) - the user can rename the batch or cal memory
to a more appropriate name.
When a new batch is created, the gauge automatically names it
‘Batch n’ - where ‘n’ is the next unused batch number; e.g. Batch 1,
Batch 2, Batch 3, etc.
To rename a batch either:
Ÿ when creating a new batch press Batch/New Batch/Rename
Batch 1; or
Ÿ press Batch/Edit Batch/Rename Batch and select the Batch to be
renamed from the list of existing batches
To rename a calibration memory:
Ÿ press Cal/Cal Memory 1; Cal/Cal Memory 2 or Cal/Cal Memory 3
Ÿ then select Rename Cal Memory n (where n=1, 2 or 3)
This then opens up the renaming procedure to enable the user to
rename the batch or cal memory.
www.elcometer.com
27
R
To Next Page
Loading...
