R
3 TAKING A READING
1. Hold the gauge (integral) or the probe by its sleeve (separate gauge)
2. To take a reading, bring the probe down onto the surface whilst
holding it perpendicular
3. For subsequent readings, lift the probe off and then replace it onto
the coated surface
Hold the probe by the probe sleeve
Gently place the probe onto the surface
Allow the sleeve to make contact with the
surface - to improve accuracy
Drag the probe over the coated surface
Bang the probe down hard onto the surface
Allow the probe to hover over the surface as
this could result in a false reading
456 Dry Film Thickness Gauge
8 of 89For more information / 1300 287 935
mail@burwell.com.au / www.burwell.com.au
To Next Page
Loading...
Need help?
General
