Electrolux T5350 - Page 52

52
Service Manual
Remount the RMC with arm.
Fasten the bolt and the washer and remount the bearing house. Use tightening torque 20 Nm ± 3 Nm.
On machines with RMC; pull the RMC flange back in position and tighten the screw. Use tightening torque 5 Nm ±
0.5 Nm.
Fasten the belt and make sure the belt is in position. Fasten the belt tensioner.
Remount the rear panel and the top panel.
Connect the door switch cable and push the cable in over the drum and pull it upwards.
fig.7549C
Remount the front panel.
Ensure that the door switch cable does not get damaged when remounting the front panel.
Remount the door.