Machine Maintenance
●Please do not use sharp or pointy tools to scrape the resin tank to avoid damaging the release liner film.
●Please clean up the resin tank before changing the resin to another color.
●Before and after printing, clean the build plate with paper towels or alcohol to ensure that there are no bumps
or burrs on the build plate.
●Before each printing, daily check the exterior of the machine and all mechanical parts for any obvious damage,
defects, or abnormalities.
●Try to keep the printing environment at 25-30 degrees Celsius when printing, and ventilate the printing room
as much as possible to facilitate heat dissipation of the machine and resin odor volatilization.
●If the Z-axis keeps making friction noise, please add some lubricant to the lead screw. Please check and apply
lubricant grease at least every 2-3 months, and increase the frequency of application as the printing frequency
increases.
●If you don't use the printer in the next 48 hours, please pour the remaining resin from the resin tank back into
the resin bottle and seal it well. If there is any residue, please use a filter to filter it out.
●The release film is a wearing part, please replace it regularly according to the machine prompts to ensure the
success rate of printing.
●Please be careful when removing the printing platform to prevent damaging the LCD screen. The service life
of the screen is about 2000+ hours and will decrease with increasing printing frequency. Do a good job of daily
screen cleaning, and unplug the machine in time after printing. If there is a screen exposure problem or service
life has seriously affected the print quality, please replace the screen in time.
17
To Next Page
Loading...
