Notice:
●Please keep the 3D printer and its accessories out of the reach of children.
●Please fill the resin tank no less than 1/3 of its volume, but do not exceed the MAX line position.
●Please place the printer in a dry environment and protect it from rain and moisture.
●If you run into an emergency during use, please turn off the power supply of the 3D printerfirst.
●Please use the printer indoors and avoid direct sunlight and a dusty environment.
●Please keep the original packaging box for 30 days for return/exchange (only ELEGOO original packaging
boxes are accepted).
●If the printing fails, you need to clean the excess cured resin in the resin tank and change the resin, otherwise,
it may cause damage to your printer.
●When operating the 3D printer, please wear a mask and gloves to avoid direct skin contact with the
photopolymer resin.
●If the release film in the resin tank is whitened, scratched, or has no elasticity, the printing failure rate is high,
please replace the release film in time.
●Please use 95% (or higher) ethyl alcohol or isopropyl alcohol to wash your model unless you are using water
washable resin.
●If you have any problems with the printer, please contact us at 3dp@elegoo.com. Please do not disassemble
or modify ELEGOO 3D printers by yourself, otherwise, the warranty will expire, and damage caused by personal
operating errors need to pay for repairs.
03
To Next Page
Loading...
