29
3 Instructions for use
Instructions for use
3.1 User interface
The controls and display views are described below.
Please note that in order to have complete visibility of all the available interfaces, the
equipment must be set to LOCAL mode and it must be accessed with the specific
passwords.
Specifically in REMOTE mode you lose visibility of the menus PASSWORD SETTING, LI-
FEXTENDER, GSM/MODEM menu and DIAGNOSTIC menu.
Rotate the encoder to navigate through the menu items.
Press the encoder to access the desired item or to browse through submenus.
To exit an item go onto the “MENU” tab and press the encoder.
To return to the previous level go to the “Exit” item and press the encoder.
If you change the value of a parameter, to maintain it, before turn off the machi-
ne wait at least 60seconds.
Warning: the screen pictures shown below and the values attributed to the parameters
are provided for illustrative purposes only. The parameters shown may vary slightly
according to the equipment and setup type of the audio board.
To Next Page
Loading...
