65
ETGSAL33
3.4.2 Connection to telemetry
This connection allows remote control through a device especially designed for that
purpose.
The telemetry unit performs the energy backup for the continuous operation of the
modem and is equipped with all the utilities for the general control of the parameters
of other equipment and the work station.
To connect to an external telemetry unit, insert a standard extension cable into the
“EIA485” connector, DB9, located on the rear panel of the machine.
This cable is supplied with the telemetry unit (Elenos code ETGSAL33).
The connection can also be made when the machine is operating.
For further information please refer to the telemetry unit manual.
Instructions for use
To Next Page
Loading...
