Elenos ETG3500 - Page 48

48
“039 USER PSU TEMP OUT LIMIT”
This indicates a variation with respect to the
conditions set by the user relating to the
power supply temperature.
“040 USER RF CURRENT OUT LIMIT”
This indicates a variation with respect to the
conditions set by the user relating to the RF
module currents.
“041 USER PSU CURRENT OUT LIMIT”
This indicates a variation with respect to the
conditions set by the user relating to the
power supply current.
“042 USER FRW PWR OUT LIMIT”
This indicates a variation with respect to the
conditions set by the user relating to the
direct power.
“043 USER RFL PWR OUT LIMIT”
This indicates a variation with respect to the
conditions set by the user relating to the
reflected power.
“044 OUT PWR NOT VERIFIED”
This indicates that the output power cannot
be detected properly.
“045 UPS ACTIVE”
This indicates that the UPS is active, therefore
the equipment is using the target power set
for operation in this mode.
“046 SHUNT COMM TIMEOUT”
This indicates the communication timeout
on the polarizer. It stops the operation of the
apparatus.
“047 WARNING TEMPERATURE SENSOR”
This indicates a fault in the temperature
probes.
“048 AUDIO OK MASK”
This indicates that the No audio alarm is
finished.
“049 DRAIN VOLTAGE FEEDBACK ERROR”
This indicates the lack of control of Vds for
causes such as power failures, wrong feeding,
etc..
“050 OVER FRW PWR ERROR”
This indicates the presence of overshoot in
power.
“058 RTC FAULT”
This indicates that there were 3 consecutive
mismatches between date/time hardware
and firmware, or the date is incorrectly for-
matted.
“059 RTC USER UPDATED”
This indicates a date upgrade.
“060 RTC AUTOMATIC RECOVERY”
This indicates that there is a misalignment
of more than 5 seconds between date/time
hardware and firmware.
Instructions for use