56
English
56
11.4.3.1 To reverse a shredding blade, proceed as follows
Warning:
Wear protective gloves as the blades are razor sharp !
Remove the machine key from the ignition.
•
Open the shredding chamber
:
• tools are not required to open the
calibration sieve. This is fitted with
a quick and easy opening/closing
mechanism
• read “11.2.5 Opening the shredding
chamber” on page 43 and follow the
steps.
Warning:
The blades are directly exposed as soon as the shredding chamber is open. Be sure
that the machine has completely stopped and remove the key from the ignition.
For your information:
The blades are extremely sharp. Avoid contact with the blades en allways wear
protective clothings.
•
Each blade is secured with two M8 bolts
. (M10 bolts on the Super Prof Max.)
Avoid injury to hands and always use two ring spanners with long handles to unscrew the bolts
.
•
Immediately replace any damaged bolts
•
Do not pull away the blades using your hands but use a self-grip wrench.
•
It is useful to put a wedge (screwdriver) in-between the blade disks to ensure it is easy to
release them.
There are a few rules that must be respected for reversing or replacing the blades. The blade shaft
has been divided into two groups for the logics of these rules:
To Next Page
Loading...
