1. Make sure that the robot arm and tools are properly and securely
installed in place.
2. Make sure that the robot arm has ample space to operate freely.
3. Never use the robot which is damaged.
4. Do not connect any safety equipment to normal I/O interface. Use
safety-related interface only.
5. Make sure to implement the correct installation settings (such as the
robot installation angle, mass in TCP, TCP offset, safety configuration).
Save and load the installation file into the program.
6. The tool and obstacles shall not have sharp angles or pinch points.
Make sure that heads and faces of all people are kept outside the reach of
the robot.
7. Be aware of robot motion when using the teach pendant.
8. Any impact will release a lot of kinetic energy, which is much higher
than that at high speed and high payload.
9. Combination of different machines can increase hazards or create
new hazards. Always make an overall risk assessment for the complete
installation. When different safety and emergency stop performance levels
are needed, always choose the highest performance level. Always read and
understand the manuals of all equipments to be used during installation.
10. Never modify the robot. A modification might create hazards that
are unforeseen by the integrator. The authorized reassembling of the robot
shall be done in accordance with all relevant service manuals of the latest
versions. If the robot is changed or altered in any way, Suzhou Elite Robot
Co., Ltd. will not take any responsibility.
11. Before transporting the robot, the user needs to check the insulation
and the protective measures.
12. Comply with the transportation requirements when carrying the
robot, as to carry carefully and avoid bumping.
1. When the robot is combined, or works with the machines capable of
damaging the robot, it is highly recommended to test all functions and the
robot program separately. It is recommended to use the temporary
waypoints outside the workspaces of other machines to detect the robot
program.
2. Suzhou Elite Robot Co., Ltd.will not take any responsibility for the
damage of the robot or personal injury due to programming errors or
improper operation of the robot.
3. Do not expose the robot to permanent magnetic fields for a long
time. The strong magnetic fields may damage the robot.
To Next Page
Loading...