41
SECTION 2: MACRODUCT ADVANCED SYSTEM SETUP
2.5 Settings Screen
Options Screen
Select Options from the Settings Screen.
The Options screen allows the operator to:
• Set a passcode
• Enable or disable tap sounds
• Define required operator input fields
Passcode Setup
1. Tap Passcode or to enable or disable passcode protection.
Selecting Passcode advances to the Passcode screen.
2. From the Passcode screen, enter a passcode by tapping on the
desired sequence of keys. The passcode must be a minimum of 4
digits and a maximum of 8 digits. After entering the passcode, tap
.
3. Enter the passcode a second time to confirm. Enter the passcode
and tap . The passcode is saved and the display returns to the
Options screen. Do not forget the passcode.
Once the passcode is selected, changes cannot be made to any
selection on the screen without entering the correct passcode.
4. To disable the passcode, tap next to Passcode, enter the
passcode, and tap . The passcode is then disabled and
returns the operator to the Options screen.
Contact ELITechGroup Technical Service for assistance if the passcode is
forgotten.
Tap Sounds
Tap or next to Tap Sounds to toggle the touch sounds on and off.
The default setting is touch sounds selected (enabled).
To Next Page
Loading...
Need help?
General