Elka MK55 - Page 38

Further HEX Code examples f Or SHL I DETUNE, SPLIT TUNF ALL OMNI ON and TUNE REQUEST;
EXAMPLE 2 . SPLFT DETUNE using PITCH command.
Should to used when you want to program a proset with a SPLIT 70NL detuned from the o + hei fs)- pro
ceed as follow:
1- Press FREE n the EDIT scclion (IE).
2 Se seta FREE position is the RANK/SPUT/FREE section (19) p for example A.
3. Press PERF. PRESET button 5. coTesponding to the IITK con t a n d
4. Write the following code- E tt 0 £> [ I-
5, Press ENTER {20).
6, Press MIDI PATCH in the EDI. sec.or (11), If the hark is protected she ri sp ey will show as below
It it is not, then go straignt to point N D 8 below.
Ban it
protec
t (=i d
s a v Q
(Yes/M
0 > 7
display
will change '0:
HID I
PATCH p 0 s l
cap
ty
9 lot 1
8. Select FREE position A by pressing buton N° 12 under ttie certral matrix < 1 6 ) (Sop MID
tion) - (9).
PATCH &sc
DisplaywiI ask:
split/altr. clian?
free A #1 0
9.
Se'sct SPLIT N Q o r ALTERNATE CHANNEL as roqhired, by pressing the respective number in the row
under ttie central matrix. SPLIT ZONE i tor example.
Disp ay wi I show:
enter value;
Oi
f r e e A #1
0
10. Now outer the VALUE required, py pressing the respective buttons on the bottom rcw. Values can be
from 0-127 with tA mpresertirg "IN TUNL". A s ignt detune can therefore be set with a value of
either C2 (flat) or 60 (Sharp).