Image selection
You can switch to camera image by pressing the
[
]
button on the operating panel or the
[
]
button on the remote control, switch to the image input to the analog RGB input terminal
[RGB IN] by pressing on the operating panel or the [
] button on the remote control, and
switch to images saved on the SD card by pressing the [
] button
on the operating
panel or on the remote control.
By connecting PCs and other devices to the analog RGB input terminal [RGB IN], you can
switch output images without disconnecting cables.
• The operating panel and remote control [ ] buttons cannot be used when the
RGB/VIDEO Switch is set to VIDEO.
•
When using a laptop PC equipped with external output selection, set the output
mode of the PC to “external” after pressing the [
] button on the operating panel
or the remote control.
•
Enters [CAMERA] mode when the output is [RGB OUT] and [VIDEO] is set for [PC]
mode.
To Next Page
Loading...
